Wagner-Smith Equipment Co.

Angle Dolly

Finally, a stringing block for line angles!  Improve safety, save time – on EVERY angle structure, EVERY time. It eliminates having to install small stringing or skookum blocks for the pulling rope, hard line or OHGW/OPGW and then stopping the pull to change them out to conductor stringing blocks.  Traditional blocks need to be physically fixed in a single angular position and watched during the entire wire stringing process to make sure the rope, hard line or conductor does not jump out of the wheel and get hung up on the dolly frame.

The Angle Dolly’s rollers prevent such issues.  The rollers are utilized almost exclusively when the lighter pilot rope, hard line or OHGW/OPGW is being pulled.  Because the Angle Dolly is free to swing, when the conductor gets to the angle, it sits down in the groove once the pull gets going while the rollers provide protection against instances when the conductor temporarily jumps out of the groove.

 

  • UL=Urethane Lined
  • Safe working load based on 3:1 safety factor
  • No ground attachments available
  • Replaceable rollers are available due to grooving
  • IMPORTANT: As with all stringing blocks, when installing on an inside angle, the Angle Dolly should be rigged low enough so it can swing freely without binding against the structure.
Clear

Recently Viewed

Products not found

inquire about this product

Thank you for your interest in this product.

Please utilize this form for product availability, product specifications or additional information. Someone from our team will be in contact with you.

Name*
Address
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Wagner-Smith Equipment Co.

FREE
VIEW