Wagner-Smith Equipment Co.

Tension Puller

Item Number: C400-1907 Category Search Terms , , Brand:

Tension Puller Switching Tool combines line-tension disconnect switch with Epoxiglas® insulated tool as above. Weathershed polymer skirts are bonded to 1.5″-diameter pole. Compression clamps secure switch hot parts to pole. Bypass stud (.5″-dia.) at each end of switch accepts 3″-wide jumper clamps.

Copper switch blade with silver-plated contacts opens to 90˚, or 180˚ with stop pin removed. Galvanized hooks are provided for operation by loadbreak device. With handling rings, this tool may be operated by either hotline tools or rubber-glove techniques. Illustrated instructions give procedures for installation, operation and maintenance. Hot line jumpers installed on conductor and tool’s bypass studs create parallel circuit. Conductor is securely restrained before cut.

  • Long tail is clamped back onto itself. Portable loadbreak device may be used to open switch.
  • For additional recommendations, refer to ANSI C37.35 IEEE Guide for the Application, Installation, Operation and Maintenance of High Voltage Air Disconnecting and Load Intrerrupter Switches.
Item Number C400-1907 Category Product Tags , , Brand:

Recently Viewed

Products not found

inquire about this product

Thank you for your interest in this product.

Please utilize this form for product availability, product specifications or additional information. Someone from our team will be in contact with you.

Name*
Address
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Wagner-Smith Equipment Co.

FREE
VIEW