Wagner-Smith Equipment Co.

Hand Held Power Supply

The Hand Held power supply is designed to provide a single phase known voltage source for the test and verification of a voltage detector. It is recommended to use this tool before and after each use of the meter to verify function of the meter to prevent false indications in the event of a tool malfunction. It is specifically designed for use on non-wired voltage detectors. The supply provides an approximately 800 volt output, varying slightly in relation to the actual voltage of the 9V battery that supplies the unit. The readings the meter will give will also slightly vary depending on the unit being tested and the position of all the components.

  • Due to the frequency output being higher than the 60 Hz our voltage detectors are calibrated to.
  • This does not affect the test results as it will still verify the meter is functioning and reading a voltage.
  • If any meter does not read a voltage, it would be considered faulty and do not use it till proper function is verified.

Recently Viewed

Products not found

inquire about this product

Thank you for your interest in this product.

Please utilize this form for availability, spec sheet request or additional information. Someone from our team will be in contact with you.

  • This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.